Installation - NewAir AWR-290DB Manual Del Propietário

INSTALLATION

Before connecting the appliance to a power source, let it stand upright
for approximately 24 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
Before operating your wine cooler for the first time, follow these steps:
• Remove the exterior and interior packing.
Clean the interior surface of the unit with lukewarm water and a soft cloth.
•
• Place the cooler on a level surface that will be strong enough to support
the unit when it is fully loaded. To level your cooler, adjust the front feet
located at the bottom of the unit.
INSTALLING THE STAINLESS-STEEL HANDLE
To install the handle, follow the instructions below:
1. Remove the rubber gasket from the right side of the inside of the door
(you don't need to remove the whole gasket, just the side that covers the
openings for the screws).
2. Remove the screws from the included bag. Feed the screws through the
holes from the inside until they poke through to the outside front of the
door frame.
3. Align the handle with the two screws, then tighten the screws into the
handle using a screwdriver until the handle is both flush and secured
tightly against the door frame. DO NOT over-tighten the screws, as you
may cause damage to the door frame.
www.newair.com
EN
9