Assembly & Installation - NewAir NCH250SS00 Manual Del Propietário

ASSEMBLY & INSTALLATION
Before connecting the appliance to a power source, let it stand
upright for approximately 2 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during
transportation.
Before using your cigar humidor, complete the following steps:
• Remove all exterior and interior packaging
• Make sure the following parts are included:
o
3 wood shelves.
o
1 Instruction manual.
Before operating your cigar humidor for the first time, follow these steps:
1. Clean the interior surface with lukewarm water using a soft cloth.
2. Place your appliance on a flat surface strong enough to support the
appliance when it is fully loaded. To level your humidor, adjust the front
legs at the bottom of the appliance.
3. Ensure the cabinet is located away from direct sunlight and sources of heat
(i.e.: stove, heater, radiator, etc.). Direct sunlight may affect its acrylic
coating. Extreme cold or hot ambient room temperatures may also cause
the appliance to not perform properly and/or increase electrical
consumption.
4. The appliance is intended for indoor use only.
CAUTION: Please keep the cabinet away from combustible materials or
substances.
Grounding instructions:
The cigar humidor must be grounded in case of wire leakage. Grounding
reduces the risk of electrical shock. The cigar humidor is equipped with a power
cord having a grounding wire and plug. The cigar humidor plug must be
plugged into a properly affixed and grounded electrical outlet.
Improper use of the grounding plug can result in the risk of electric shock.
Consult a qualified electrician or service person if the grounding instructions
are not completely understood.
www.newair.com
EN
9