DeWalt DC602 Manual Del Usuario página 41

Inserting and Removing the
Battery Pack from the Tool (fi g. 2)
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
NOTE: Make sure your battery pack (m) is fully
charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the notch inside the tool's handle with the
battery pack (m).
2. Slide the battery pack firmly into the handle until
you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release buttons (n) and firmly pull the
battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
Low Battery Indicator (fi g. 1)
The low battery indicator is an integrated feature in
the headlights (e). It will blink 4 times to indicate that
the battery pack needs to be recharged and the tool
will automatically shut down.
Switch off the tool and take out the battery pack (m)
to charge it as soon as the indicator blinks.
The tool remains non-operational as long as a low
battery pack is attached to it.
Mounting the Belt Hook (fi g. 3)
The belt hook may be attached to either side of the
tool or removed if not desired.
1. Insert the belt hook (f) into the mounting slot on
the side of the tool.
2. Pass the screw (r) through the mounting hole.
Tighten the screw.
Loading the Tool (fi g. 4)
WARNING: Always turn tool off and
disconnect battery pack before loading
and unloading fasteners.
1. Press the pusher release button (h) and pull the
magazine (g) rearward.
2. Select an appropriate collated nail stick. (See
Technical data.)
3. Insert collated nail stick into the loading slot on
side of the magazine. Be sure the fasteners ride
on their tips in the nail channel.
4. Push the magazine forward until it locks in
place.
Low Nail Indicator (fi g. 7)
When approximately six nails remain in the
magazine, the low nail indicator (i) will appear
in the magazine window.
The presence of the yellow indicator signifies that
the magazine needs to be reloaded with nails.
Adjusting the Driving Depth (fi g. 5)
Using the depth adjustment wheel, the nail driving
depth can be adjusted to the type of fastener used.
1. To drive the nail shallower, rotate the depth
adjustment wheel (k). There are twelve depth
settings with 6 intermediate positions – 1 being
the shallowest and 6 being the deepest.
2. To sink a nail deeper, rotate the depth
adjustment wheel to a higher setting.
Selecting the Mode (fi g. 1)
To select sequential action mode, slide the mode
selector switch (j) to the single nail icon (
To select bump action mode, slide the mode
selector switch (j) to the three nail icon (
Contact Trip Lock-off (fi g. 6)
This tool is equipped with a contact trip lock-off
(l) which prevents the tool from firing a nail.
To engage the contact trip lock-off (l), push the
switch downward.
To release the contact trip lock-off (l), pull the switch
upward.
WARNING: Make sure the contact trip
lock-off (l) is engaged and the battery
pack is removed before making any
adjustments or when tool is not in
immediate use.
Headlights (fi g. 1)
This tool has headlights (e) located on each side.
The headlights will light upon inserting the battery
pack and upon activating the trigger or releasing the
contact trip. The headlights also function as a low
battery indicator and a jammed nail indicator. For
further details, refer to Low Battery Indicator or
Clearing a Jammed Nail.
EN GL IS H
).
).
39