Eldom atmo NU9 Manual De Instrucciones página 9

DESCRIPTION
1. Handle
2. Nozzle
3. Water tank
4. Water-level gauge
5. Body
6. Control panel
7. Remote control
CONTROL PANEL (6)
REMOTE CONTROL (7)
A ON/OFF
B SPRAY
C
TIME
D
HUMIDITY
E PRURIFY
F SLEEPMODE
G
ANION
H
COMFORTABLE
TECHNICAL DATA
- power: 28 W
- supply voltage: 230V ~ 50Hz
- capacity: 4 l
- output: 360 ml/h
- humidifier output for a 35m
- humidifier operation time for a full
container: approx. 11 hours
INTENDED USE
The NU9 ultrasound humidifier is intended to improve quality of air in residential premises.
SETTING THE HUMIDIFIER
- Make sure the device is disconnected from the power supply.
- Remove the tank (3) by gripping the handle (1) and the body (5).
- Turn the tank, undo the nut (photo 2) and fill the tank with water. Secure the nut
by tightening it firmly.
- Place the tank (3) onto the body (5).
OPERATION
All changes in the settings are confirmed with an audio signal.
- Connect the device to the power supply compatible with the parameters stated
above. The appliance will enter the stand-by mode. No function is active, and the
display is switched off.
ON/OFF (SWITCHING ON / SWITCHING OFF)
Pressing the button (A) will cause the display to activate. The humidifier will start running at the lowest level of humidification,
with the fan motor running. The humidity level is displayed. Pressing the button (A) again will switch off the unit and make it
enter the stand-by mode.
HUMIDITY (MIST)
The appliance is fitted with a three-stage control of humidification. The level of humidification is changed with the button (D).
INSTRUCTION MANUAL
ULTRASOUND HUMIDIFIER NU9
room
2
1
7
A
2
C
3
D
4
Hygrostat
Humidity
5
3
2
Anion
1
ON/OFF
Humidity Level
A
6
Humidify
B
Hygrosta t
C
photo 2
EN
B
E
F
Timer
Temperature
C
H
Sleep
F
Anion
E
Time r
D
•
EN 9