DESCRIPTION OF THE APPLIANCE, BASIC PARTS
See fig. 1, page 1
On/ off switch for interior light
1
I -(ON) O –(OFF)
2
Thermostat knob
3
Thermostat indicator
Electricity supply indicator
4
(green light) *
5
Interior light block (LED)
When the appliance is connected to the electricity supply, the green indicator light is
*
illuminated.
Keys you will find on the shelf of the appliance.
INSTALLATION AND OPERATING CONDITIONS OF THE
Preparing the appliance for operation
It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base. Do not
•
rise or push it taking by handles.
Therefore take out adhesive tapes from sides and simply lift the appliance up and
•
take out the board. Strip adhesive tapes off and open the door. Remove the spacer
above the door.
When positioning the appliance in chosen location, it will move more easily into
•
position if you lift the front a little and incline it backward allowing it to roll on its
casters.
Take two supports from the bag and insert them into the guides at the top back part
•
of the appliance (see fig. 2, page 1).
If the appliance is brought in from the cold (temperature is not higher than +12
°C), you should wait for two hours before connecting it to the mains.
The appliance should not be connected to the mains until all packing and
transport materials aren't removed. Suitably dispose the packaging material.
Positioning
Place the appliance in a dry, well ventilated room.
•
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
WARNING! The appliance must not touch any pipes for heating, gas or
water supply or any other electrical devices.
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
7
Adjustable height shelves
8
Thaw water channel cleaner
9
Condenser
10
Compressor
11
Carbon filter
APPLIANCE
6