BAUKER BG200 Manual De Instrucciones página 25

3. Mount the wheel guard and keep the distance between the
wheel guard and the wheel not over 2 mm. (see the figure on
the right).
The adjustment of the wheel guard is intended to reduce the
damage in the grinding wheel. It must be gradually adjusted to
keep the distance between the wheel and the wheel cover as
short as possible but it must not be over 2 mm.
4. Before installing the wheels, check their quality. Try them according to a sound test (
hammer the wheels. The sound should be clear)
5. Install the wheels fastening the wing nuts included in the kit.
6. Switch the tool on without using the wheels at least for 5 minutes to be sure about the
mounting of the pieces. Keep away from the work area to avoid injuries
Do not operate the tool continuously to avoid overheating.
Always wear hearing and eye protections to avoid hazardous situations.
51
Warning: Always disconnect the bench grinder from the power source before performing
any assembly or adjustment. If you must replace a grinding wheel, be sure to obtain one
with a safe rated speed at least as high as the "no load speed" RPM marked on the data
plate of the grinder.
1. Remove the flange nuts and the work rest
2. Remove the screws and the eye shield
3. Remove the spark breaker
4. Loosen the three bolts and remove
the wheel guard.
Installation
and set off
Changing the griding wheel
52