Maintenance And Cleaning - BAUKER HG2031L Manual De Instrucciones

• A hot nozzle can ignite a surface. Lay down hot nozzles only on fireproof surfaces.
• Incorrect or improper nozzles may cause heat build-up and damage to the unit. Only
use original nozzles suitable for your unit according to the table
Note the mains voltage. The voltage of the power supply must fit the value shown on
the technical specifications plate in the product. Extension cords must have a
conductor section of at least 2 mm2 x 1.0 mm2.
SWITCH ON: Set the switch to 1, 2 or 3. Set the desired temperature by turning the heat
control knob on the back of the unit to the right (+) or to the left (-).
SWITCH OFF: To cool the unit, set the switch to 1, and operate the unit in COOL DOWN.
When the unit has cooled down, set the switch to 0.
49

Maintenance and Cleaning

Start-up
Before performing any type of work on the unit, make sure it is unplugged. For safe and
efficient work, always keep the unit with the air vents clean.
Maintenance and Cleaning
USE
50