URBANGLIDE F3 Manual De Instrucciones página 6

Introduction
Before using your URBANGLIDE electric bicycle, it is important to read this user manual carefully. It is important to find
out about the regulations in place in your city, town, municipality, or country before using the product. Do not lend your
bike to anyone who is not familiar with this type of product.
Before using it for the first time, as well as for all other uses, check that all parts are properly assembled and in good
condition. If you have any questions, do not hesitate to contact us. You can also visit a specialist near you to analyse
and adjust your bike as best as possible. It is essential that the parts you assemble yourself: seal, handlebars, pedal,
are well assembled and checked regularly.
This bike is designed to be used on flat roads and slopes, but also on mixed surfaces such as mountain roads, forest
roads and gravel roads. However, it is not designed for jumping or tricks. Any user who does not respect these rules
will be held responsible in the event of an accident.
a) First use
- Check that the handlebars and stem are correctly tightened.
- Check that screws, bolts and other nuts are properly tightened.
- Check that the brakes are working properly.
- Check tyre pressure and condition
- Check the operation of the lights and reflectors
- Make sure the battery is fully charged
- Insert the battery into the bike, turn the key to turn on your battery.
- Start your bike by pressing the ignition button on the left handle for 2 seconds.
- Once the screen is switched on, it will display the battery status, assistance level, time, distance and speed.
- The engine starts when you start pedalling. Before starting to pedal, make sure that the assistance speed is at 0.
- To adjust the assistance level, press the "+" and "-" buttons on your display. The higher the level, the greater the
assistance.
b) Before each use
- Check the condition of your tyres
- Check your tyre pressure
- Check that no parts, bolts, screws, etc. are missing.
- Check that the brakes are working properly
- Check the functioning of the electronic parts
- Check that the lights are working and that the reflectors are in place.
- Check the condition and operation of the battery.
c) Recommended tightening
- Front axle nuts: 46N.m
- Rear axle nuts 70N.m
- Handlebar and stem clamping bolts 12N.m
- Handlebar stem expansion bolt 10N.m
- Seat column clamping nut 5-8N.m
- Saddle clamp nut 24N.m
- Gear lever nut 4N.m
- Rear support nut 8N.m
- Mudguard support nut 8N.m
6