Safety Warning; Important - NEO PROTON IP Manual De Usuario

1.2 Safety warning

Important

• This product be installed by a qualified professional.
• All maintenance must be carried out by a qualified elec-
trician.
• A minimum distance of 0,5m must be maintained be-
tween the equipment and a combustible surface.
• The product must always be operated in a well ventilat-
ed area.
• DO NOT stare directly into the LED light source.
• Always disconnect the power before carrying out any
maintenance.
• The earth must always be connected to the ground.
• Ensure that all parts the equipment are kept clean and
free of dust.
2. Installation
2.1 Mounting
Hanging - The fixture can be mounted in a hanging position
using the supporting bracket. The bracket should be secured
to the mounting truss or structure using a standard mounting
clamp. Please note that when hanging the unit a safety cable
should also be used.
Upright - The fixture can be mounted in an upright sitting
position using the supporting brackets.
PROTON IP
ENGLISH VERSION
2.2 power connections
@220V: 50 units may be connected in series
@120V: 25 units may be connected in series
2.3 setting up with a DMX521 controller
• Connect the DMX512 controller to the units in series.
• Each unit has 13 DMX channels so the DMX Addresses
should increase by increments of 1, (Nx1) + 1, (Nx2) + 1,
(Nx3) + 1, ....
• The ID address has not been set so therefore when using
the controller CH 10 must be inactive (CH10=0).
• It is also possible to deactivate ID address selecting [ID
OFF] from the [Settings] menu, on the fixture.
• Each DMX Address may be used as many times as required.
• Any DMX address in the range from 001 to 512 may be used.
Example
The fixture above shows a simple DMX512 layout with the
starting address of the first unit set at 1, with the second set at
(Nx1)+1and so on...
(Note that when used in this way, the Ch10 ID function must be
inactive (CH10=0))
p. 3