KIT PREPARATION
1. Remove (4) Phillips screws securing the display to the factory panel, then remove the display.
2. Unclip and remove the hazard button.
3. Install both items to the 95-7344 radio trim panel using the factory hardware.
4. Attach the (4) panel clips provided onto the 95-7344 radio trim panel.
Continue to Kit Assembly
White
plastic
clips
(Figure A)
1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory antenna connector
in the dash and complete all necessary
connections to the radio. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS. Do
not turn the key to ignition to test the
radio until step 4
White
3. Secure the completed assembly to the
plastic
dash using the factory screws. (Figure B)
clips
4. Connect the factory connectors to the
display and hazard button, then clip the
radio trim panel to the dash. Test the
radio and all factory features for proper
operation.
5. Reassemble the dash in reverse order of
disassembly. (Figure B)
KIT ASSEMBLY
(Figure A)
(Figure B)
REV. 5/29/2018 INST95-7344
3