Master Appliance PORTA PRO GG-100 TM Manual De Instrucciones página 5

Fill with Ultratane
Use only Master Ultratane butane with your Glue Gun. Do not
fill gas or store near open flame, heater, furnace or combustible
materials. Make sure the unit is cool before re-fueling and that
the switch is turned to the "OFF" position. Fill gas holding the
unit firmly with the refill nozzle pointed upwards. Insert nozzle
into the gas filling valve and press down. Use pumping action
for best results (Fig. 1). Gas will overflow from nozzle when
tank is full. After filling allow the gas to stabilize for a few min-
utes before lighting.
Ignition Instructions
1. Use only 1/2" diameter glue sticks. Insert glue stick through
tunnel at the back of gun (Fig.2).
2. Push the Fuel Flow Control upward (Fig.3A) and turn wheel
to the right (+) enough to hear a small "Hissing" sound (Fig.
3B).
3. Push the "Ignition Switch" to ignite the flame. Hold for about
5-10 seconds before releasing (Fig. 4).
4. After igniting, the ceramic elements inside the air vent will
glow "red" (Fig. 5). Tip the gun forward on folding stand
under the nozzle to stand the gun. Wait for a few minutes for
it to heat up and allow the glue to melt and soften.
5. To increase the fuel flow, adjust the Fuel Flow Control to the
right (+) (Fig. 6)
Adhesive Application
1. Direct nozzle tip at any clean/dry surface you wish to bond.
Check for proper adhesive selection.
2. To apply melted adhesive use steady finger pressure on
feed trigger. Release feed trigger to stop flow of adhesive.
3. Do not use excessive pressure on feed trigger.
4. Insert 1/2 inch glue stick into transport mechanism as
needed.
Butane
™
1
(Fig 1)
2
A
B
3
4
5
6