Bwt Technology In A Piccolo Trend Heater; Door Switch - Helo PICCOLO Trend Instalación Y Manual De Uso

Installation and User Manual Piccolo Trend

2.15. BWT technology in a Piccolo Trend heater

Bio Water Technology (BWT) uses the heater's thermal energy to heat water and raise the moisture level without
a separate heat source. Moisturised air improves the sauna climate, and various fragrances and salts can be
evaporated to make the sauna experience more enjoyable.
A water tank with a lid is delivered with the heater; the tank can be installed in the wider gap between the heating
elements. The water tank can be installed when approximately 2/3 of the heater stones have been stacked. The water
tank, even when empty, does not need to be removed when the heater is on.
The tank has a capacity of approximately 1,4 litres. Bringing water to the boil when the tank is full takes approximately
1-2 hours depending on the set temperature.
It is recommended to pour water into the tank when the heater is turned off. Water is poured through the grate on the lid.
You can pour less water into the tank if the bathing time is shorter.
The water tank must be removed and impurities, such as limescale etc. removed every so often. The stones surrounding
the tank must be removed during cleaning, so that the tank can be lifted more easily.
When the water is boiling, the moisture levels in the sauna remain high. This means that the temperature can be kept
lower while still experiencing pleasant heat. More heat and moisture can, if necessary, be created by throwing water on
the stones on top of the heater.
Mild fragrance essences, suitable for heater use, can be put in the water tank.
You can, for example, put mountain salt crystals on the lid of the water tank. They dissolve into the steam and evaporate
into the air. If mountain salt crystals are placed in the water tank, the salinity of the water will remain 26%.
1
1

2.16. Door switch

The door switch refers to the switch on the sauna door. This switch complies with regulations. Public and private saunas
must have a door switch, i.e. saunas where the heater can be switched on from outside the sauna, e.g. using an On/Off
button or a similar method.
If the door is opened before the heating sequence is started, (pre-set heating) automatic use (remote use) is disabled after
one minute. The door must be closed and the function restarted from the control panel.
If the door has been left open for more than five minutes while the heater is on, the heater is automatically turned off.
The heater can be turned on again from the control panel after the door is closed.
For installation and user instructions, please refer to the manual supplied with the door switch accessory, which is sold
separately.
2
2 3
3
4
4
H O
2
max1,4 l
12