Metra 99-6544B Instrucciones De Instalación página 3

KIT PREPARATION
1. Cut and remove the shaded area from
the sub-dash to allow clearance for the
aftermarket radio. (Figure A)
Continue to Kit Assembly
Remove
shaded area
(Figure A)
KIT ASSEMBLY
ISO-DIN radio provision with pocket
1. Attach the radio brackets to the radio
trim panel using (4) #8 x 3/8" Phillips
screws supplied. (Figure A)
2. Attach the pocket to the bracket
assembly using the (4) supplied
#8 x 3/8" Phillips screws. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the completed
assembly, and then secure it to the
assembly using screws supplied
with the radio. (Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra
and/or AXXESS. Test the radio for
proper operation.
6. Reassemble the dash in reverse order
of disassembly.
(Figure A)
(Figure B)
(Figure C)
REV. 5/14/2018 INST99-6544B
3