Use; Hob Care And Maintenance - Franke FHM 704 4G Instrucciones Para El Uso E Instalacion

Use

Igniting the burners
The control knobs on these models incorporate both ignition and a burner safety device.
To ignite the burners, proceed as follows:
1. Turn the chosen control knob.
2. Keep the knob pressed down for 3 or 4 seconds in order to allow the sparks to ignite
3. After 3 or 4 seconds, release the knob and turn it anti-clockwise to adjust the flame to
Symbols
Circle
large flame
small flame
Burner use
For better use of the burners and more efficient gas consumption, use pans whose
diameter is proportional in size to that of burners. Ensure that flames do not extend
beyond the edge of pans (consult the table).
Automatic safety valve
This safety device automatically shuts off the gas supply in the event one of the burners
goes out accidentally as a result of a sudden draught, a pot spilling over, or an interruption
in the gas delivery. This device intervenes approximately 30 seconds after the burner
flame has gone out.

Hob care and maintenance

Before carrying out any cleaning or maintenance operations on the hob, always unplug the
appliance or switch off the power at the mains using the main switch.
• Stainless steel and enamelled parts will remain pristine if regularly cleaned with water
• To restore the original sheen, from time to time use Franke's specially formulated
• Under no circumstances must scouring pads, steel wool, muriatic acid or other
• Do not leave acid or alkaline substances or rusty iron items on the hob.
• The burners and flame-spreader crowns can be removed from the hob and cleaned
• The natural colour of panstand grids, where pots and pans rest, may alter over time as
12
the gas as it exits through the flame-spreader crown, and to allow the thermocouple to
heat up.
the desired setting. If the flame goes out, repeat the operation from step 1.
: tap closed;
: maximum gas delivery;
: minimum gas delivery.
and proprietary detergents. Remember to dry carefully after cleaning.
stainless steel cleaner and microfibre cloth, both available from your retailer or Franke
After-sales Service.
products which might scratch or grind the surface, be used.
with hot soapy water; dry thoroughly after cleaning. Make sure that gas outlet areas
are spotlessly clean.
a result of heat. To clean the panstand grids, proceed as with the burners.