Canon imageCLASS LBP113w Introducción página 7

Ocultar thumbs Ver también para imageCLASS LBP113w:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
For details
"Setting Up Using the Setup Guide" in the User's Guide
3.
Take note of the SSID and network key.
• Check the label on the router.
• The setting operation is easier if the router is
provided with a WPS mark.
4.
Set the access point and network key
according to the screen below.
For more
information, refer
to the manual.
OK
1. Select <OK>.
2. Select <SSID Settings>.
3. Select <Select Access Point>.
4. Select the access point (SSID).
5. Enter a WEP key (network key), and Select
<Apply>.
6. Select <Yes>.
• The IP address will be automatically
configured in a few minutes.
• "Connected." is displayed.
5.
Install the driver and software.
P.8 "Installing the software"
Now you are finished with the
configuration of the initial settings.
User's Guide
User's Guide
To connect via USB
• Do not connect the USB cable before installing
the driver. If you did, disconnect the USB cable
from the computer, close the dialog box, and
then perform the following procedure from
step 1.
1.
Install the driver and software.
P.8 "Installing the software"
• When the screen to connect the USB cable to
the machine is displayed, remove the tape that
covers the USB port.
Now you are finished with the
configuration of the initial settings.
Quick Setup
En
7

Publicidad

Tabla de contenido
loading

Tabla de contenido