Installation; Programming - Axxess GMOS-044 Instrucciones De Instalación

CONNECTIONS
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the ASWC-1 (not included) to retain steering wheel
audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be used, refer
to the ASWC-1 instructions for radio connections and programming. Disregard the harness
that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
Note: The relay attached to the GMOS-044 is only for audible turn signal clicks. No extra steps are
required to retain this, so leave it as-is.
(CONT)

INSTALLATION

With the key in the off position:
• Connect the GMOS-044 harness into the interface, and then to the wiring harness in the vehicle.

PROGRAMMING

Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio doesn't come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
3
REV. 8/26/2019 INSTGMOS-044