Filter Replacement; And Care Of Filters - Kenmore 758.15412010 Manual De Uso

Replacement and Care of Filter
WARNING: To reduce the
risk of shock or injury from
moving parts, always unplug
humidifier before removing
or replacing any parts.
6. Return the housing assembly to the
top of the base. Reposition the
humidifier to its operating position.
7. The humidifier is now ready to be
filled for operation.
CAUTION: To help retard bacteria
growth and keep maximum
efficiency, the filter should be
replaced at least once per season,
or more often under hard water
conditions. Use Kenmore 32-14906
recommended replacement filter.
Replace the evaporative wicking filter
at least once per humidification
season or more depending on water
conditions in your area.
Filter Replacement
1. Unplug humidifier. Before removing
the filter, we recommend moving the
humidifier to an area where floor
coverings are not susceptible to water
damage. (i.e. kitchen or bath areas.)
2. Remove the water bottle and set
aside. Be sure not to bump or
damage the fill valve.
3. Grasp the housing assembly and lift
straight up and away from the base
and set aside. The filter is now
accessible.
4. Take note of the filter position.
Remove the filter. You may want to
clean the base at this time. See the
"Cleaning Your Humidifier" section of
this manual.
5. Install a new filter (32-14906) into the
base. Coil the filter and position it
between the uprights in the bottom of
the base. The start and finish of the
coil should be captured at the center
of the base (see diagram) and the
filter should be resting on the floor of
the base.
Grasp housing
assembly
securely and
lift off .............. \\\_
Position start
. and finish of
coiled filter at
of base
/ top of base
/ and reposition
securely