Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3. Water Fill
WARNING:
To reduce
the risk of fire
or shock hazard,
do not pour or spill
water
into control
or motor
area.
If
controls
get wet, let them dry
completely
and have unit checked
by
authorized
service personnel
before
plugging
in.
After the humidifier
is positioned
where
it will be operating
you are ready
to
fill the humidifier.
The bottle
lifts
straight
up and away
from the base.
Take care
not to bump or damage
fill
valve
assembly
on the bottom
of the
bottle.
Remove
the "E-Z Fill Side Cap"
and fill
with water.
Replace
cap and twist by
hand
until secure. Hold the bottle
upright
over the sink. Press up on the
valve
plunger
for one second
to release
a small amount
of water.
If you hear
air bubbles
or see leaks around
the "E-
Z Fill Side Cap"
or Spring Valve
Assembly,
retighten
and recheck.
CAUTION:
Use only 32-14900
EPA
Registered
Bacteriostat
available
from
Sears Retail store. Under
no
circumstances
should you use water
treatment
products
designed
for Roto
belt or Ultrasonic
humidifiers.
Bottle \
Turn Counterclockwise
to
Remove "E=Z Fill Side Cap"
/
Spring Valve
Assembly
Place the water
bottle
back into the
humidifier
base. When
positioned
properly,
the plunger
will open and
the water
will flow
into the base. The
base will hold the entire
contents
of
the water
bottle.
Once the bottle
is
empty,
remove
it and repeat
the
filling
process.
The humidifier
is now
filled
to capacity.
To benefit
from
less
frequent
filling,
let the humidifier
exhaust
both the water
from the
bottle
and the base before
filling.
Publicidad
Tabla de contenido
