MAXIMUS MDO0265027MPWC2 Manual De Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION
This lamp can be installed into 5 in. and 6 in. housings.
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list. If any part
is missing or damaged, do not attempt to assemble the product. NOTE: Product is shipped in the 6" installation configuration.
If installing in a 6" housing with ears, no adjustments are necessary. However, if installing in a 6" housing without ears or a 5"
housing, the appropriate instructions must be followed.
Tools required for assembly (not included): Phillips screwdriver
INSTALLATION
For 6" / 6.5" housings with ears
Step 1 (Fig. 1)
Remove existing trim and CFL or incandescent bulbs. Screw
adapter (B) into socket in recessed housing.
Step 2 (Fig. 2)
Plug base cable connector into lamp (A).
Step 3 (Fig. 3)
Compress spring clips (D) and insert into ears on inside of
recessed housing.
Step 4 (Fig. 4)
Carefully route wires into fixture. Push retrofit into recessed
housing until the trim is flush with the ceiling surface.
For 5" housings with ears
Step 1 (Fig. 5)
Remove existing trim and CFL or incandescent bulbs. To
install in 5" housings, loosen the screws on each side of the
friction clips with a Phillips screwdriver.
Fig. 1
B
Fig. 3
Ears
Fig. 4
Fig. 5
6
5
6" POSITION
3
Fig. 2
A
D
5
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mdo0265030mpwc2Mdo0265040mpwc2Mdo0265050mpwc2

Tabla de contenido