Bosch PMF 10,8 LI Manual Original página 23

OBJ_BUCH-1170-002.book Page 23 Tuesday, May 11, 2010 3:36 PM
Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding
sheets are available:
Sanding disc Material
– All wooden materi-
als (e.g., hard-
wood, softwood,
chipboard, building
Red quality
board)
– Metal materials
– Paint
– Varnish
– Filling compound
– Filler
White quality
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Bosch Power Tools
Application
For coarse-sanding, e.g. of rough, un-
planed beams and boards
For face sanding and planing small
irregularities
For finish and fine sanding of wood
For sanding off paint
For sanding primer (e.g., for removing
brush dashes, drops of paint and paint
run)
For final sanding of primers before coat-
ing
Connecting the Dust Extraction (see figure A)
Remove the application tool/accessory when
mounting the dust extraction 18 (accessory).
If required, assemble the parts of the dust extrac-
tion 18 as shown in the figure. Position the as-
sembled dust extraction onto the machine via the
tool holder 7. Turn the dust extraction in such a
manner that the cams of the dust extraction en-
gage into the corresponding recesses on the
housing. Fasten the dust extraction to the ma-
chine with the retaining clip 16 as shown in the
figure.
Pay attention that the felt ring 15 is undamaged
and faces tightly against the sanding plate 12.
Replace a damage felt ring immediately.
Place a vacuum hose 19 (accessory) onto the
vacuum connection 17. Connect the vacuum
hose 19 with a vacuum cleaner (accessory). An
overview for the connection of various vacuum
cleaners can be found at the end of these instruc-
tions.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
English | 23
Grain size
coarse 40
60
medium 80
100
120
fine 180
240
320
400
coarse 40
60
medium 80
100
120
fine 180
240
320
2 609 004 157 | (11.5.10)