Troubleshooting - Team kalorik TKG SIS 11 Manual De Instrucciones

Fax +32 2 359 95 50
ANTI-CALC DEVICE
• Your appliance is equipped with an anti-calc device located inside the water tank. As a
result, you can use tap water as it will be filtered by the device.
• Never use the appliance without water tank!
CLEANING
• The plastic parts of the appliance can be cleaned with a damp cloth.
• To clean the soleplate of the iron, you will find specific products in the shops. Please also
read the instructions of use. Never use abrasive products to clean it.
• Never immerse the appliance in water or any other liquid.
TROUBLE-SHOOTING
Problem
White flour comes out
of the soleplate
Water drips from the
soleplate when steam
ironing
No steam comes out of
the steam tank
No steam comes out of
the iron when the
steam button is pressed
The soleplate is dirty
PROTECTION OF THE ENVIRONMENT– DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Possible cause
This is normal when the iron is new
When you start steam ironing, the
steam fitter is still cool and the
steam will cool down
The steam control knob has not
been turned on or there is not
enough water in the water tank
When ironing at a high
temperature, steam with a too
high temperature cannot be seen
Impurities in the water adhere to
the soleplate or the temperature
is too high for the clothes
14
Assembly page 14/56
Solution
The flour is not harmful and will
disappear after a few times
This is normal; after a few seconds,
the steam jet will be OK. You can
put the iron on an old cloth to
start so that the water is absorbed
Turn the steam control knob to the
desired position or fill the water
tank and wait until the indicator
light of the iron goes out
Put a mirror under the soleplate to
check if steam comes out
Clean the soleplate with a soft,
damp cloth or adjust the
temperature
on the
TKG SIS 11 - 080531