Esoteric P-02 Manual Del Usuario página 23

RCA output setting
RCA> ***
Sets the RCA connector digital output mode.
The factory default setting is "OFF".
ON
The RCA connector output follows the upconversion setting.
OFF
There is no output from the RCA terminal. Select this setting when
not using the RCA terminal.
THRU
Upconversion is not used, and output occurs at a sampling
frequency of 44.1 kHz.
NOTE: DSD signals cannot be output from the RCA connectors.
i.LINK output setting
i > * **
Turns i.LINK (AUDIO) connector output on or off.
The factory default setting is "OFF".
ON
Upconversion is not used during CD playback and the signal is
output at the standard sampling frequency of 44.1 kHz. During
Super Audio CD playback, the DSD signal is output.
OFF
Nothing is output from the i.LINK connectors. Set to OFF when not
using the i.LINK connectors.
< To output Super Audio CD surround sound, set the output to
"Multi" channel. When set to "2ch", the downmixed signal will be
output through only the front left and right channels (see page 19).
< If there is a problem with sound output, refer to the manual for the
connected amplifier or D/A converter and confirm that the format
is supported.
< If the receiving device connected to the i.LINK connector supports
flow rate control, the signal will automatically be output using flow
rate control mode.
DAC (D/A converter setting)
DAC> ***
Select the type of D/A converter connected.
The factory default setting is "ESL3".
ESL1
Select this setting when connecting to the Esoteric D-01.
ESL2
Select this setting when connecting to an Esoteric D/A converter
other than the D-01 or D-02.
ESL3
Select this setting when connecting to the Esoteric D-02.
Others
Select this setting when connecting to a D/A converter that is not
an Esoteric D/A converter.
< When the setting is "ESL3", if the "upconversion setting" is "ORG",
"2Fs" or "4Fs", the PCM signal will be output at 48-bit, and if "8Fs", it
will be output at 24-bit.
LAYER (priority playback area)
LAYER> ***
There are two most common Super Audio CD (SACD)types: SACDs
with DSD layers only that provide user selectable choice of 2-channel
layer or Multi-channel layer, and hybrid SACDs that contain a 2-channel
SACD (DSD) layer and a CD layer.
The factory default setting is "SACD".
When a hybrid Super Audio CD is loaded and when the playback is
stopped, press the PLAY AREA button to select a playback area.
SACD:
This mode gives priority to the Super Audio CD layer. The 2-channel
layer plays back when "2ch/Multi ch" is set to "2ch", and the multi-
channel layer plays back when set to "multi ch".
CD:
This mode gives priority to the CD layer.
< Selecting a layer that is not on the disc results in playback of the
layer found on the disc.
< Even if the playback layer has been changed using the PLAY AREA
button when playback is stopped, when a different disc is loaded
this is overridden by the LAYER setting.
23