Digital Check SmartSource Micro Elite Manual Del Usuario página 2

Step 4 – Preparing Documents for Processing
To improve document throughput and scanning, it is recommended
that the operator perform the following document preparation steps
prior to loading documents into the scanner:
•
Remove all staples, paper clips and rubber bands
•
Straighten any bent corners, folds, creases or curls
Step 5 – Prior to Inserting Documents into the Scanner
To insure proper document feeding, it is recommended that the
Operator perform the following steps prior to loading
documents into the scanner input hopper:
1. All documents are facing the correct direction
2. Align the leading and bottom edge of all of the documents
8227 4738-002 October 2016
SmartSource Micro Elite – Setup and Operation
© 2016 Digital Check Corp.
Step 6 – Inserting Documents into the Scanner
•
Place document into the feeder bay, aligning the bottom edge
of the document with the feeder bay floor
•
Align the leading edge of the documents with the check graphic
located on the top cover (as shown)
•
Align ID cards with the bottom surface of the ledge (as shown)
Front Entry – Check Insertion
Step 7 – Scanner Operation
Use of the SmartSource Elite requires application software. Please
contact your IT department or solution provider for assistance with
the installation and use of any required check processing software.
Step 8 – Clearing Document Stops
Front Entry- ID Card Insertion
Methods to clear documents from the
track:
1. Hold power button down for 1
second and release
2. Pull documents out of the scanner
in the direction shown
CAUTION: Do not pull documents out
straight up.
Page 2 of 16