Installation To Wood Stud - peerless-AV SAX762PU Instrucciones De Montaje

Installation to Wood Stud Wall
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
Using a stud fi nder, locate and mark the edges of the wood stud. Use a level to draw a vertical line down the center
2
of the stud and mark the desired display center. Use wall plate template (wall arm) to mark center of holes along
the vertical line. The top mounting hole should be 8.55" (217mm) above the desired display center as shown in
fi gure 2.1. Drill four 3/16" (5mm) dia. pilot holes to a depth of 3" (76mm). Attach wall arm (A) to wall using four wood
screws (C) and four support plates (N) as shown in fi g. 2.2.
WOOD STUD
fi g. 2.1
DC = DISPLAY CENTER
8.55"
(217mm)
DC
WARNING
fi g. 2.2
C
A
5 of 41
WOOD STUD
N
ISSUED: 01-25-12 SHEET #: 095-9370-7 01-07-14