Mounting - Tripp-Lite SmartOnline SU16KRT El Manual Del Propietario

Mounting

Note: It is recommended that the following mounting instructions only be used in standard rack enclosures and 4-Post Open Frame Racks.
1
It is important to note that in order to accommodate paralleling
applications, equipment must be mounted in the following order
(see diagram): UPS Power Module 1, UPS Power Module 2,
Battery Module 1 and Battery Module 2.
Note: The power module and battery module must be installed in
separate shelves.
2
The included plastic pegs
B
rackmount shelves while you install the permanent mounting
hardware. Insert a peg near the center of the front and rear
bracket of each shelf as shown. (Each front bracket has 6 holes
and each rear bracket has 3 holes.) The pegs will snap into
place.
After installing the pegs, expand each shelf to match the depth
of your rack rails. The pegs will fit through the square holes in the
rack rails to support the shelves. Refer to the rack unit labels to
confirm that the shelves are level in all directions.
Note: The support ledge of each shelf must face inward.
B
3
Secure the shelves to the mounting rails permanently using
the included screws and cup washers
• For 2U equipment mounting, place 4 screws total at the front
and 4 screws total at the back.
• For 3U equipment mounting, place 6 screws total at the front
and 4 screws total at the back.
Tighten all screws before proceeding.
Warning: Do not attempt to install your equipment until
you have inserted and tightened the required screws. The
plastic pegs will not support the weight of your equipment.
4 D
Attach mounting ears
E
equipment using the screws provided
forward.
5
Using an assistant, lift your equipment and slide it onto the
mounting shelves. Attach your equipment to the rack by passing
the screws, nuts and washers (user-provided)
mounting ears and into the rack rails.
A
will temporarily support the empty
C
as shown.
to the front mounting holes of your
F
. The ears should face
G
through its
1
A
2
B
C
3
C
3
E
4
G
5
4
UPS Power Module 1
UPS Power Module 2
Battery Module 1
Battery Module 2
B
A
C
B
F
D
C