Assistance With Problems; Technical Data - Intenso MEMORY PLAY Instrucciones De Uso

ASSISTANCE WITH PROBLEMS

Status LED is not illuminated
Check the external hard drive and the USB cable for visible damages. Should there be damage
please contact our Support to exchange it. Under no circumstances use the defective device or
cable. Check that the cable connection is plugged correctly.
Hard Drive is not recognized
Check the points under "Status LED is not illuminated" first.
Please check all further USB ports of your device (in particular on the rear side of PCs), it is
possible that the hard drive does not get enough power at the used USB port. Please use only
the supplied cable and, in particular, no extension.
If you use a USB hub between hard drive and computer, this should have an own power supply.
If the hard drive is not recognized at any USB port of your device, please try if it works on
another device to exclude a possible defect.
Check the Disk Management, it is possible that only a drive letter has to be assigned (please see
the Help file of your Windows version).
If you have used the hard drive previously, for example on a TV set, it could be that you have to
format the hard drive first so that you can use it on a computer again (please refer to the ope-
rating instructions of the previously used device and/or the Help file of your operating system
provider for details).

TECHNICAL DATA

EXTERNAL USB 3.0 HARD DRIVE 2.5" (6.35CM)
Dimensions (2.5" housing):
Transfer rate:
Capacity calculation:
13 x 78 x 127 mm
max. 5 GBit/sec (USB 3.0)
1 MB = 1,000,000 bytes/
1 GB = 1,000,000,000 bytes
EN - Page 5 of 7