Rowenta ACCESS FRESH AIR PLATINIUM EP8990D0 Manual De Instrucciones página 16

1800111731 EP8990E0.qxd
• Cleaning the shaving head
- Stop and unplug the device.
- Remove the protective hood (19).
To do so: hold the appliance firmly and place your fingers on the grip
zone (17) on the shaving head and then pull upwards. You will
remove the protective hood (19) from the blade block (18).
- Carefully remove the hairs by blowing on and around the micro grid
(15)
Never use the small brush for cleaning the micro grid (15).
DO NOT PRESS ON THE MICRO GRID WHEN PUTTING IT BACK INTO PLACE.
Do not apply alcohol to the body of the appliance in order to avoid damaging its colours.
Do not use a metal or sharp tool.
• Clean the trimmer head.
Stop the appliance and unplug it.
Press the release button to remove the epilator head .
Remove the comb and clean hair from the trimmer head with the
brush .
Rinse the trimmer head under cold tap water for 5 or 10 seconds.
Shake the trimmer head vigorously and dry it with a towel.
IMPORTANT
Systematically clean the appliance's trimmer head after each use.
The appliance must not be submerged in water. It must not be used in the shower or
bath.
• Cleaning sensitive
areas accessory
25/10/07
You can also run the protective hood (19) and the blade block (18)
under running cold water to remove all the hair. Shake the parts well
and then dry them using a towel without pressing down on the
micro grid before reassembling them.
- Put the protective hood (19) back on the blade block (18). You will
hear a click.
14
11:19 Page 14