Assembly And Adjustments; Saw Blades - DeWalt DWE305 Traducido De Las Instrucciones Originales

EN GLI SH
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
2
conductor size is 1,5 mm ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Mounting the Saw Blade (fi g. 2)
1. Move the blade clamp lever (b) up to release
the blade clamping mechanism.
2. Insert the saw blade into the holder (d) until it
engages. The blade can be installed with the
teeth pointing down or up, or left or right.
3. Move the blade clamp lever (b) down to lock the
blade clamping mechanism.
4. To remove the saw blade, proceed in reverse
order.

Saw Blades

material recommended saw blade
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
WARNING: Always select your saw
blade with great care.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
22
Proper Hand Position (fi g. 1, 4)
Proper hand position requires one hand on the back
fine-toothed
handle (g), with the other hand on the front grip (e).
coarse-toothed
Switching On and Off (fi g. 1)
coarse-toothed
fine-toothed
To run the tool, press the variable speed switch (a).
The pressure exerted on the variable speed switch
carbide-tipped
determines the tool speed.
To stop the tool, release the switch.
Always switch off the tool when work is finished and
before unplugging.
Cutting Wood
1. Clamp the workpiece securely and remove all
nails and metal objects.
2. Holding the tool with both hands, work with the
saw shoe pressed against the workpiece.
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Ensure the material to be sawn is
secured in place.
• Apply only a gentle pressure to the
tool and do not exert side pressure
on the saw blade. If possible, work
with the saw shoe pressed against
the workpiece. This prevents damage
to the blade and stops the tool from
jerking and vibrating.
• When sawing in walls or doors be
aware of the location of pipework and
wiring. Always hold the tool by its
handle.
• Avoid overloading.
• Let the blade run freely for a few
seconds before starting the cut. Never
switch on the tool when the saw
blade is jammed in the workpiece or in
contact with the material.
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.