8
SAFETY INSTRUCTIONS
y Do not turn the product On/Off by plugging-in or unplugging the power plug to the
y
wall outlet. (Do not use the power plug for switch.)
It may cause mechanical failure or could give an electric shock.
y Please follow the installation instructions below to prevent the product from
y
overheating.
» The distance between the product and the wall should be more than 10 cm.
» Do not install the product in a place with no ventilation (e.g., on a bookshelf or in a
cupboard).
» Do not install the product on a carpet or cushion.
» Make sure the air vent is not blocked by a tablecloth or curtain.
Otherwise, this may result in fire.
y Take care not to touch the ventilation openings when watching the TV for long
y
periods as the ventilation openings may become hot. This does not affect the
operation or performance of the product.
y Periodically examine the cord of your appliance, and if its appearance indicates damage or
y
deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact
replacement part by an authorized servicer.
y Prevent dust collecting on the power plug pins or outlet.
y
This may cause a fire hazard.
y Protect the power cord from physical or mechanical abuse, such as being twisted,
y
kinked, pinched, closed in a door, or walked upon. Pay particular attention to plugs,
wall outlets, and the point where the cord exits the appliance.
y Do not press strongly upon the panel with a hand or sharp object such as nail,
y
pencil or pen, or make a scratch on it, as it may cause damage to screen.
y Avoid touching the screen or holding your finger(s) against it for long periods of time.
y
Doing so may produce some temporary or permanent distortion/damage to screen.
y When cleaning the product and its components, unplug the power first and wipe it
y
with a soft cloth. Applying excessive force may cause scratches or discolouration.
Do not spray with water or wipe with a wet cloth. Never use glass cleaner, car or
industrial shiner, abrasives or wax, benzene, alcohol etc., which can damage the
product and its panel.
Otherwise, this may result in fire, electric shock or product damage (deformation,
corrosion or breakage).
y As long as this unit is connected to the AC wall outlet, it is not disconnected from the AC power source
y
even if you turn off this unit by SWITCH.
y When unplugging the cable, grab the plug and unplug it, by pulling at the plug. Don't
y
pull at the cord to unplug the power cord from the power board, as this could be
hazardous.
y When moving the product, make sure you turn the power off first. Then,
y
u n p l u g t h e p o w e r c a b l e s , a n t e n n a c a b l e s a n d a l l c o n n e c t i n g c a b l e s .
The TV set or power cord may be damaged, which may create a fire hazard or
cause electric shock.