Mutsy NIO Manual De Instrucciones página 29

Attach and remove bumper bar (t1)
· To secure the front bumper, press the ends of the bumper into the
recesses intended for this purpose on the seat until you hear a click.
· Press the unlock buttons on both sides of the front of the bumper bar
to remove the bumper bar from the chair.
The hood (u1, u2)
· Hold the front hood bar in the centre and move it forwards or rearwards
to adjust the hood (u1)
· Open the zipper at the back of the opened hood in order to enlarge it.
Close the zipper to again reduce the hood (u2)
· Pull the flap on the front side of the hood outwards to additionally
enlarge the hood. Push the flap inwards to again reduce the hood.
Assemble the rain cover on the pushchair (v)
· Make sure that the hood of the seat is in the upright position.
· Open the zipper in the rain cover in order to attach it to the enlarged
hood of the seat.
· Place the rain cover from top to bottom over the pushchair and make
sure that the rain cover is attached well behind the back support and
over the leg support.
The 5-point safety harness (w1, w2)
· Place your child in the pushchair and make sure that the legs of your
child are placed on each side of the leg piece.
· Make sure that the hip and shoulder belt is positioned correctly over
your child and place both plastic clamps in the central part of the
harness attached to the leg piece (w1).
· To adjust the length of the shoulder straps, loosen the shoulder
protectors from the belt by undoing the velcro. This will reveal the belt
buckles. Adjust the length by sliding the buckles along both shoulder
straps until your child is comfortably secure. After adjusting, press
down the velcro on both sides to relock the shoulder protectors in
place.
· The backrest contains three positions for the shoulder belts. To modify
the position, open the zip behind the backrest (w2). Loosen the
shoulder belts by moving the attachment rings through the openings.
Move the attachment rings through the desired openings so that the
shoulder belts are positioned properly.
· Regularly check the length and position of the belts and adjust, where
necessary.
EN
23