Description Of Components; Intended Use; Improper Use - Carl Stahl Kromer 7228 Manual De Instrucciones

Instructions for Use – Zero Gravity Balancers

DESCRIPTION OF COMPONENTS

(1) Rating plate
(2) Safety suspension
(2.1) Locking screw (7241, 7248, 7251, 7261)
(3) Anti-crash safety device
(4) Elastic cable stop buffer
(5) Cable clamp
(6) Cable wedge (for cable length adjustment)
(7) Ferrule (for securing the free cable end)
(8) Shaft (for load adjustment)
(9) Load hook
(10) Adjusting screw (worm)
(11) Ratchet lock
(12) Cover disk

INTENDED USE

 The zero gravity balancer is exclusively designed for relieving (counterbalancing) the weight of
hand-held tools (such as drilling machines, screwdrivers, welding tongs, slaughterhouse ma-
chines) and feed lines (such as cables and hoses) during work.
 Any other or additional use shall be considered non-intended use! The manufacturer/supplier
shall not be responsible for any damage resulting from such use. The risk posed by improper use
shall be borne by the user alone.
 The zero gravity balancer may only be operated within the load range specified on the rating
plate.
 Using the balancer outside the field of application described above shall void the warranty unless
the written consent of Carl Stahl Kromer GmbH was obtained beforehand.
 The zero gravity balancer may only be operated, installed, serviced and repaired by specially
trained personnel.

IMPROPER USE

 The zero gravity balancer must not be used as a crane.
 The drum lock must not be used for load replacement.
SAFETY INSTRUCTIONS – ACCIDENT PREVENTION
 No changes may be made to the balancer or its accessories without the express written consent
of the manufacturer.
 The safe use of this product is only ensured if you have fully read and understood these user and
safety instructions and observe them strictly during work.
 The balancer may only be operated and installed by specially trained personnel. These persons
must previously have been informed about the potential hazards involved in performing these
tasks.
 The balancer may only be serviced and repaired by qualified personnel that has been specially
trained or authorized by the manufacturer.
 Taking the balancer apart is extremely dangerous and therefore strictly forbidden.
 The fixtures to which the zero gravity balancer and the anti-crash safety device are to be fastened
must provide sufficient stability!
 Never operate the zero gravity balancer without the safety equipment supplied (anti-crash safety
device) in place.
Only 7241 0800 81...87
(13) Manual drum lock
Only 7248:
(14) Cable guide nozzle
(15) Cable mouth
(16) Cable coupling screw
(17) Cable coupling bush
(18) Swivel
(19) Load cables (2 items)
(20) Transport clamp
Only 7261:
(21) Pulley
GB / US
33