Technical Data - Rockwell Sonicrafter X2 RK5140K Manual De Instrucciones

3.0A OscillAting tOOl

tEchnicAl dAtA

Rated voltage
Amps
Oscillations speed
Oscillations angle
Protection class
Tool weight
OPErAting instructiOns
nOtE: Before using the tool, read the instruction book
carefully.
1. mOunting AccEssOriEs
cAutiOn: For all work or when changing accessories,
always wear protective gloves. Avoid danger of injury
from the sharp edges of the accessories. Accessories can
become very hot while working, presenting danger of burns!
make sure the tool is unplugged prior to changing
accessories.
WArning: to reduce the risk of injury, do not let the
sharp side of the accessory face back toward the user's
hand.
The Hyperlock™ tool-free system allows you change the accessories
without using an Allen key.
- Flip the Hyperlock™ Accessory Clamping Lever forward
to the open position. (See Fig. A)
- Rotate the Lever counterclockwise to loosen the Flange.
- Insert the accessory onto the Universal Fit
then press down the Flange with finger to keep blade temporarily
secure. (See Fig. B)
- Rotate the Lever clockwise until accessory is tightened Securely.
(See Fig. C)
- Flip lever back down to seated position.
nOtE: For prior model Rockwell Sonicrafter
accessories and most other non-Rockwell branded accessories,
the Flange must be completely removed to install accessory. (See Fig. D)
2. mOunting / chAnging thE sAnding shEEt (see Fig. E)
Align the Sanding Sheet and press it onto the Sanding Pad by
hand. Align the holes of the perforated Sanding Sheets with the
holes of the Perforated Sanding Pads when used.
Firmly press the power tool with the Sanding Sheet against a flat
surface and briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn after use, pull off the Sanding Sheet,
turn it 120° and replace.
nOtE: For other various brands, use smaller flange provided.
120 V~60 Hz
3.0 A
11000-20000/min
3.2°
3.3 lbs
Accessory Interface,
TM
hex-interface
®
/II
A
2
B
1
C
D
E
Eng
1
2
7