Package Contents; Installation Instructions - Torch 2.0 Manual Del Usario

Each Package includes one ba�ery, one ba�ery charger, the Torch Coat Heater™,
two installa�on kits, each consis�ng of three adhesive backed Velcro pads.
Please read all the installa�on instruc�ons before you begin.
Note: Please visit www.torchcoatheater.com for video instruc�ons.
Step 1 - Select a coat compa�ble with Torch. It is important that the adhesive has a
smooth surface to s�ck to. Polyester type linings work the best while fuzzy liners
like fleece may not adhere adequately.
Step 2 - Locate the ideal loca�on of each Velcro pad by physically placing your
Torch Coat Heater™ in the coat to see where it fits. The ideal loca�ons on the
inside of your coat are shown below, leaving a minimum of a 2" gap between the
strap of your Torch Coat Heater™ and the armhole of your coat.
Step 3- Unpeel the Velcro pads and place inside the coat. Do this for all 3 adhesive
backed Velcro pads.
Be careful to keep the adhesive free from dirt
and debris. Place the adhesive Velcro pad in
the desired loca�on. Make sure it is lined up
with the seams of your coat or any other
pa�erns so the Velcro pads look even. Gently
place the Velcro pad on the coat liner, before
pressing on the pad make sure the liner is flat
by spreading it �ght with your hands. Then
press firmly on the Velcro pad, making sure
that each edge adheres adequately to the coat
liner.

PACKAGE CONTENTS

INSTALLATION INSTRUCTIONS

2 Inches
Make sure the straps between the heat
pads fit below the arm hole.
2
Note: The adhesive on the back of
the Velcro loops take 24 hours to
reach maximum strength. Do not
pull on the Velcro during this period.