Publicidad
Idiomas disponibles
Idiomas disponibles
User Manual
01
02
03
A
04
Strip the wires
INSTALLATION CUBO FLAT ANCHOR
Use a Phillips head screwdriver to tighten the
screws holding the side anchors.
Remove the V/D connectors with a fine-tipped
screwdriver.
Run the V/D cables through the opening in the
end cover.
Attach the RJ-45 connectors on the cover
connectors and crimp as shown in figure A.
Put the cover on the rail with the connectors
and gather up the extra cable.
The profile frame is completely installed.
INSTALACIÓN CUBO CETAS A 90º
Con un destornillador de punta philips atornillar
las zetas de sujeción de los laterales.
Publicidad
