Maintenance; Specific Maintenance - BE Power Equipment HW3024HG12V Manual Del Operador

MAINTENANCE

SPECIFIC MAINTENANCE

ENGINE: The engine instructions that accompany your unit detail specific procedures for maintenance of
the engine. Following the engine manufacturer's recommendations will extend the engine's life and ensure
the best possible performance.
PUMP: Change the pump oil after the first 50 hours of operation. After the initial change, every 3 months
or 250 hour intervals are recommended. If oil appears dirty or milky, changes may be required in greater
frequency. Use SAE 30 non-detergent pump oil and fill only to the center of the oil sight glass. DO NOT
overfill.
B
Sight
Glass
NOZZLE: Water flow through the spray nozzle will erode the orifice over time, making it larger. This will
result in a reduction of pressure. Nozzles should be replaced whenever pressure is less than 85% of the
maximum. The frequency of replacement will depend upon such variables as mineral content in the water
and number of hours the nozzle is used. Every 3-6 months tends to be a standard interval for replacement.
A
BEPOWEREQUIPMENT.COM
2
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
REPRODUCTION IN PART OR AS A WHOLE
NEXT ASSY
WITHOUT THE WRITTEN PERMISSION OF
<INSERT COMPANY NAME HERE> IS
PROHIBITED.
2
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
INTERPRET GEOMETRIC
TOLERANCING PER:
MATERIAL
FINISH
USED ON
APPLICATION DO NOT SCALE DRAWING
1
<COMPANY NAM
NAME DATE
DRAWN
TITLE:
CHECKED
ENG APPR.
MFG APPR.
Q.A.
COMMENTS:
SIZE
DWG. NO.
A
SCALE: 1:2
1
TSF202
15