GIBBON Slacklines TRICKLINE MODULAR Serie Guía De Uso página 2

TRICKLINE MODULAR SERIES - HIGH PERFORMANCE SLACKLINE EQUIPMENT -
As a pioneer in easy to use - plug and play - slackline sets, GIBBON has extended their product range to
modular systems. The MODULAR SERIES product range is placed between sets and single parts, making
sure advanced slacklining is reliable and easy to handle. Always wondered what single parts to combine
to make an expert slackline? We've got you covered! The GIBBON MODULAR SERIES contains modules
put together from the best slackline parts on the market to ensure you have selected the right equipment
for an easy to handle, reliable, and high performance slackline! Only to be used with GIBBON products as
part of the GIBBON MODULAR SERIES. It is strongly advised not to use any other material or slackline
systems with the GIBBON MODULAR SERIES.
For an easy and safe setup, GIBBON recommends the setupvideo under the following link:
https://vimeo.com/105321933
1. Installation of the first TRICK TENSION ANCHOR
1.1 Wrap TREE WEAR XL around tree or pole and fasten with velcro patch (A)
1.2 Wrap round sling around tree and use the velcro straps (B) to secure.
Gibbon
1.3 Connect round sling and ratchet (upside down) with shackle (C). Make sure the pin is fully
screwed back in and the shackle screw is facing the ratchet strap. Avoid closing the screw
with too much force, or else the shackle will become difficult to open after use.
Leave the installation hanging and approach other side!
1. Installation of first Trick Tension Anchor
2
1.2
B
FRONT
1
1.1
B
A
REAR
2. Installation of the second TRICK TENSION ANCHOR
2.1 Wrap the TREE WEAR XL around tree or pole and fasten with velcro patch (A)
3. Installation of X14 Module Webbing on first Anchor
2.2 Wrap round sling around tree and use the velcro straps (B) to secure.
2.3 Connect round sling and ratchet (upside down) with shackle (C). Make sure the pin is fully
screwed back in and the shackle screw is facing the ratchet strap. Avoid closing the screw with
3.1 3.2
too much force, or else the shackle will become difficult to open after use.
D
E
3. Installation of slackline webbing (ANDY LEWIS TRICKLINE, SLAMINA ...... ) on first
TRICK TENSION ANCHOR
E
3.1 Start with either side and pull the ratchet extension release lever (D) and unfold ratchet
extension lever (E) 180° until it locks in place in a flat position.
3.2 Release ratchet lever (G) by pulling on the safety handle (F) to unfold ratchet to 90°.
3.3 Thread the chosen webbing (H) through drum slot (I) of the ratchet, min. 1 foot / 30cm
3.4 Hold webbing and excess webbing together tightly under tension and start applying the
4. Applying initial tension with the second Trick Tension Anchor
ratchet lever handle (G) to coil up the drum more than one full rotation so that the slackline is
fixed. The webbing is then anchored.
MANUAL - ENGLISH
4.1 4.2
D
E
1.3
C
C
F
G
MANUAL ILLUSTRATION
2. Installation of second Trick Tension Anchor
2.1
A
3.3
I
4.3
I
H
HOW TO SET UP YOUR TRICKLINE
2.3
2.2
B
FRONT
B
REAR
1
3.4
H
G
4.4
C
2.5
MAX