Qiachip KR2202 Manual Del Usuario página 6

How to set the working mode of the switch
controller?
1. The working mode can only be set when the <LED 1 >indicators of the switch
Note:
controller are lit.
2.When there is no operation after power-on, <LED 1> and <LED 2> are always
on. When the switch is in the setting state, the state of <LED 1> does not change,
and <LED 2> is the setting status light.
3.In the following description, all descriptions about LEDs are <LED 2>.
Step 1) Press the receiver's learning button once.
Set Momentary mode :
Wait for the LED on the receiver to light off and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the
receiver will flash and then turn off.
Step 3) At this time, press another button (such as B) of the same remote control,
the indicator flashes and then lights up. The Momentary mode is set successfully.
Step 1) Press the receiver's learning button twice.
Set Toggle Mode:
Wait for the LED on the receiver to light off and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the
receiver will flash and then turn off.
Step 3) At this time, press another button (such as B) of the same remote control,
the indicator flashes and then lights up. The Toggle Mode is set successfully.
Step 1) Press the receiver's learning button 3 times.
Set Latching Mode:
Wait for the LED on the receiver to light off and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the
receiver will flash and then turn off.
Step 3) At this time, press another button (such as B) of the same remote control,
the indicator flashes and then lights up. The Latching Mode is set successfully.