Battery Installation - BluMill bts-750 Instrucciones De Uso

Battery Installation

EN
1
Pull the battery tray out
of the remote control
battery compartment.
INSTRUCTIONS FOR USE
Charge the speaker
For best results, fully charge the speaker before using it for the first time.
1. Connect the USB charging cord (included) to the speaker's DC 5V charging port and
insert the other end into a port on your computer or a similar power source.
2. The red light will light up to indicate that the battery is being charged. Once it is fully
charged, the red light will go off. It will take around 4 to 5 hours to charge the battery
to full capacity.
Turn your device on or off
Press and hold the Power button for 2 to 4 seconds until you hear a sound. The LED light
will light up and flash. Your speaker is now on and is going into pairing mode.
Press and hold the Power button for 2 to 4 seconds to turn the speaker off.
4
Note: The speaker automatically pairs with previously paired devices.
2020-12-16 OCG BluMill Light Up Speaker Manual V02.indd 4 2020-12-16 OCG BluMill Light Up Speaker Manual V02.indd 4
Before using for the first time, remove the
insulation pull tab from the battery compartment
of the remote control.
The remote control requires one CR2025/32
Lithium battery. When the battery runs out, replace
it as explained below:
2
Place a new CR2025/32
button cell battery in the
tray slot with the positive
terminal facing upwards
as shown in the picture.
3
Close the battery tray.
23-12-2020 13:31 23-12-2020 13:31