Qiachip KR1201A Manual De Instrucciones página 6

corresponding relay; press the receiver button 5 times to pair, delay 10S to close
Corresponding relay; press the receiver button 6 times to pair, delay 15S to close
the corresponding relay; press the receiver button 7 times to pair, delay 20S to
close the corresponding relay;)
How to set the working mode of the switch
controller?
The working mode can only be set when the LED light indicators of the switch
controller are lit.
Step 1) Press the receiver's learning button once.
Set Momentary mode :
Wait for the LED on the receiver to light on and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the
receiver will flash and then turn off. The Momentary mode is set successfully.
Step 1) Press the receiver's learning button twice.
Set Toggle Mode:
Wait for the LED on the receiver to light on and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the
receiver will flash and then turn off. The Toggle Mode is set successfully.
Step 1) Press the receiver's learning button 3 times.
Set Latching Mode:
Wait for the LED on the receiver to light on and enter the setting state.
Step 2)Press the button on the remote control (such as A) once. The LED on the
receiver will flash and then lights up.
Step 3) At this time, press another button (such as B) of the same remote control,
the indicator flashes and then turn off. The Latching Mode is set successfully.
Step 1) Press the learn button on the receiver as required,
Delay mode (timed):
(Delay time: Press the learn button on the receiver 4 times delay 5S to close the
corresponding relay; press 5 times for 10 seconds, press 6 times for 15 seconds,
press 7 times for 20 seconds)
Wait for the LED on the receiver to light up and enter the setting state.
Step 2) Press the button (eg button A) on the remote control once. The LED
indicator on the receiver will flash and then turn off, the delay mode is
successfully set.