CG Drives & Automation 01-5464-00 Manual Del Usuario página 7

Mounting the frame
If the AC drive is mounted in a cabinet, it may be appropriate to place the
control panel in the cabinet door.
NOTE: A control panel with display can not be used on the AC drive and the
cabinet door at the same time, one of the panels must be blank.
1. Cut a hole in the cabinet door according to the template on page 59.
2. Place the mounting frame into the hole from the outside of the cabinet
door.
3. Fasten the mounting frame in the cabinet door from the inside using the
three mounting clamps and screws according to the Fig. 3.
Cabinet door
Mounting clamps
Fig. 3 Mounting the mounting frame using the mounting clamps.
CG Drives & Automation 01-5912-11r0
Mounting frame
5