Vinylexpress Q Serie Guía De Usuario página 239

Step 3: Print design data.
After creating the design, print it on the media.
Supplement
Pay attention to the following when printing to prevent registration mark scan from failing when cutting.
•
Set the enlarge/shrink scale to 100% (Do not enlarge the design during the printing or cutting phases).
•
Set the printing position (center/lower left etc.) so that the positional relationship between the created document and the printed
result is the same.
Operation
3-1 Print design data for printing and cutting.
Select the printer to use from the Print menu of LXI Expert, Master or Master Plus 19 and print
the design with the registration marks added in LXI.
Step 4: Cut the printed media.
Cut the media prepared in Step 3 with the cutting plotter.
Operation
4-
1 Load the printed media on the cutting plotter.
MARK TYPE 1
4-2 Send the cutting data to the cutting plotter using the File/Cut-Contour command.
MARK TYPE 1
MARK TYPE 2
MARK TYPE 2
Move here Move here
13-6
Supplement
•
For loading media, see "Loading Media (Paper
or Marking Film)".
•
If a registration mark scanning error occurs,
check the registration marks etc. (See
"ARMS".)