Loewe Equipment Board FS Trapeze Instrucciones De Montaje página 12

9
10
11
12
A
Mounting the Equipment Board FS
Trapeze
Place the previously removed cover back on the Equipment
Board and screw it tight with the screws removed beforehand.
Push the assembled Equipment Board FS Trapeze into the hol-
der in the Connect TV set, fi g. 10.
If you intend, for example, to place two recorders on the
Equipment Board FS Trapeze, the clamping screws (fi g. 10, sec-
tion, arrow A) should be offset in the tube of the Equipment
Board FS Trapeze.
We suggest turning the clamping screws into the fourth pair of
holes from the bottom as shown in the section.
If you only intend placing one recorder on the Equipment
Board FS Trapeze, we suggest turning the clamping screws into
the third pair of holes from the bottom.
Tighten the screws through the opening in the rear panel of
the TV, fi g. 11.
This clamps the carrier tube of the Equipment Board FS Trapeze
tight in the TV set.
Tighten the two screws with a torque of approx. 2 Nm, fi g. 11.