STM ROBOTICS STM-1SM Manual De Instrucciones página 28

Troubleshooting
When I transfer, my colors look faded.
You need to increase the amount of time you're pressing and/or increase the temperature.
My heat press displays temperature on Fahrenheit instead of Celsius.
Press both arrow buttons ← → for 8 seconds, then use ← → to set the number "001", press "MODE" to save
the settings.
The heat press displays "0000".
If you see this, turn the machine off and back on. If that doesn't fix it, please contact our support group as a
replacement part might be necessary: STM ROBOTICS (81) 3849 3020, (81) 1306 9219, (81) 1306 9220.
The heat press beeps and displays "E2".
Check if the press connection cable is connected.
26