Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the mounting plate
Carefully unpack and lay all parts on a clean, level surface.
Unscrew the canopy nuts (C) from the fixture assembly (B)
and detach the mounting plate (A).
Install the mounting plate (A) to the junction box (not
included) with two junction box screws (AA).
T
NOTE:
he preassembled screws from the mounting
plate should be in a horizontal position.
A
AA
3
Installing the fixture assembly
Place the fixture assembly (B) against the mounting
surface, allowing the preassembled screws on mounting
plate (A) to pass through the fixture assembly (B) and
secure with previously removed canopy nuts (C).
A
B
C
A
B
C
2
Making the electrical connections
NOTE:
Make the connections to a 120V AC 60Hz circuit.
Connect the white wires from the fixture to the white wire
of the supply circuit. Connect the black wires from the fixture
to the black wire of the supply circuit. Wrap the bare copper
grounding wire from the fixture around the green screw on
the mounting plate, then connect it to the grounding
conductor of the supply circuit. Use U.L./C.S.A. listed wire
connectors (BB) suitablefor the size, type and number of
conductors. Secure the wire connectors with
U.L./C.S.A. listed electrical tape.
BB
4
Installing the bulb and shade
Remove the pre-attached socket ring (F) from the fixture
assembly (B). Place the plate (D) and shade (E) over the
socket on the fixture assembly (B), then secure with the
socket ring (F).
Use three 60 Watt Maximum, Type A bulbs or CFL
equivalent or LED equivalent (bulb not included).
2
F
E
D
B
Publicidad
