Operation Tutorial - smaco S300 Manual Del Usuario

04

OPERATION TUTORIAL

4.1 Assembly
S300 scuba is divided into two parts: the cylinder valve and high-pressure
cylinder. When receiving the product, please check any possible missing parts.
Remove the screw protection sleeve at the bottom of the cylinder valve and
check the thread connection. After careful check, please tighten the cylinder
valve and have it inflated for use.
4.2 Inflation
Please check any possible air leakage when inflating. In case of any leakage,
stop the inflation immediately; the gas filled is compressed air (it's strictly
forbidden to fill in pure oxygen or other gases harmful to human body). When
the air pressure in the cylinder reaches 3000psi /200bar/20Mpa, stop the
inflation immediately to avoid any accidents;
Common Inflation Methods: electric pump inflation, manual pump inflation
and adapter inflation. When the aforesaid tools are used, please ensure that
the pressure can reach 3000psi/200bar/20Mpa, otherwise the cylinder will
not be fully filled. When electric pump/manual pump is used for inflation,
oil-water separator shall be equipped;
The compressed air filled shall meet the requirements of human breathing to
ensure the air is pure and harmless to human body. If the pure compressed air
suitable for human body is not filled as required, the filter system or channel
in the cylinder valve may be blocked to cause malfunction.
05