raydan 26048 Manual Del Usuario página 8

WAY OF EMPLOYMENT
It choose always a safe place for the heater, taking into account the cautions of security
described. Ensure that all the packaging have been withdrawn of the unit before his use. This
device does not require installation, has to use only like a portable device.
WARNING: Keep all the objects at least to 1 metre of the frontal part, lateral and back of the
device.
WARNING: to avoid the overheating, do not cover the heater.
WARNING: Never it leave this heater neglected.
WARNING: Have care when planting his heater, use the timer will mean that the heater will light
automatically. It can produce a fire if it plants at the side of material fuel.
Note: When it lights the device for the first time, can give off a light smell or smoke. This smell
or smoke is a normal occurrence caused by the initial warming of the elements of internal
warming and does not have to occur again.
FUNCION FAN
In addition to the three configurations of heat, there is a fan with a switch of lit / turned off separate
situated in the signpost of control. The function Fan is to distribute heat to the room to a faster speed.
OPERATION OF THE HEATER
NOTE: it Is normal when the heaters light for the first time or when they light after have not been used
during a long period of time, the heaters can issue something of smell and smoke. This will disappear
when the heater have been lit by a short time.
SWITCH OF CONTROL OF HEAT
The positions of the switch of control are:
0 - Desactivado
750W - Low heat
1250W - half Heat
Both: high heat
It check that the switch of control of heat was in the position of turned off before enchufar the heater to
the electrical network. For a greater economy, use the configuration of heat high initially and afterwards
change to the configuration of low heat.
THERMOSTAT
It turn the knob of the thermostat in time sense until reaching the maximum temperature in the scale
graduated. When it reaches the temperature acclimatise wished, turn slowly the knob in sense
antihorario until the heater turn off (will listen a click). The heater now will light and will turn off to keep
the temperature established.
TIMER
The device always will be lit when the switch deslizante was in the position "I".
The device always will be turned off when the switch deslizante was in the position "Or".
To configure the timer; it adjust the switch MODE to the position of the timer.
(This function only can use once that it has selected a level of heat; it consult the section of the
thermostat).
It has to configure the time before programming the timer. To do this; it turn the external dial of the
timer in a clockwise direction until the hour of the day (clock of 24 hours) correspond with the triangular
mark. Example, if they are the 14:00 (1400 hours), plant the triangular mark on line with 14. A complete
turn of the dial corresponds to 24 hours.
There are 96 "runners", planted around the dial, each runner represents 15 minutes.
Where all the "riders" are pushed to the outside of the timer, the device will be LIT continuously. To
establish a specific time, for example: