Simon, Evers & Co K 176 339 Instrucciones De Manejo Y Mantenimiento página 8

8. If a leak occurs in the hose or reel, remove system pressure immediately.
9. Ensure that reel, hose, and equipement being service are properly grounded.
10. If reel ceases to unwind or rewind, remove system pressure immediately.
11. Do not pull or jerk on hose.
Warning: Exposure of skin directly to pressurzied air, or fluids could result in severe bodily injury.
Installation
1. Prior to mounting the hose reel, ensure that the supply line pressure does not exceed the maximum working
pressure of the hose reel.
2.Unpack and inspect reel for damage. Turn by hand to check for smooth operation. Check for completeness.
3. Place the reel on the flat floor, the one with bigger friction the better.
Operation
1.Check reel for correct operation by slowly pulling out hose. A "clicking" noise will be heard evey half
revolution of the drum.
2.To latch the reel, pull out the hose and allow it to retract after hearing the first second or third "clicking".
3.To unlatch, slowly pull out the hose and untile the "clicking" noise stops, then let cable retract until the cable
stopper rests against the cable guide.
4. If necessary, adjust spring tension on reel by adding or removing wraps of hose from spool, one wraps at a time,
until desired tension is obtained. Add wraps to increase tension.
Remove wraps to decrease tension.
WARNING! Do not open the plate (#19) at will. It is very dangerous and can cause serious personal
injuries. See below picture.
7