Conant JEFFERSONIAN WV1LFB Instrucciones De Ensamblaje

English
To fully enjoy this beautifully crafted Je ersonian Kinetic Wind Vane, please read the following information.
The Je ersonian Kinetic Wind Vane was inspired by Thomas Je erson's a nity for invention and based on the design of a 19th century
centrifugal regulator. The beautiful aluminum cups will gently sweep around the main shaft and as the wind increases, the hinged joints will
allow the aluminum arms to rise and indicate the relative wind speed depicted in timeless illustrations on the solid brass arrow below.
Additionally, the brass arrow will gently turn to face the direction of the wind.
The instrument is made of solid brass and aluminum construction with glass accents. Within a few month's exposure to the elements, the
brass nish will begin to age gracefully and develop a mellow patina. This aging process is what we call "Living Finish Brass. "
Ideal Instrument Placement: For best indications of wind speed and direction, place your Kinetic Wind Vane in an open area that is
unobstructed by buildings and trees.
Tools Needed:
For Ground Mounting:
Rubber Mallet
Approximate installation time -
For Ground Mounting:
1. Clear a smooth, at
surface on the ground.
Then place the base on
the ground with the
Conant logo facing up.
3. Screw the hexagonal nut
into the top of the
foundation rod (#3a) while
being careful to maintain
the same angle of tilt. Using
a rubber mallet, drive the
foundation rod into the
ground until the top of the
rod is about 1/8" from the
top of the base (#3b).
214 Eastern Avenue, Annapolis, MD 21403
JEFFERSONIAN KINETIC WIND VANE
ASSEMBLY INSTRUCTIONS
For Deck Mounting
Phillips Head
Screwdriver
minutes
Base
3a
Foundation
Rod
www.conantcollections.com
#WV1LFB
Included Hardware:
4 Wood Screws
Drill
2. Insert the foundation rod
into the hole at the top of
the base. Then screw the
level into the top of the rod
to verify that it is plumb.
Shift the rod's tilt until the
bubble is in the center of the
level's ring. When you are
done, unscrew and remove
the level while keeping one
3b
hand on the foundation rod
to keep it level.
4. Tighten the two set
screws on the base using
the Allen wrench. Then
unscrew and remove the
hexagonal nut from the
top of the foundation rod.
*Note: Images are not to scale or actual size.
Hexagonal
Nut 2 Allen Wrenches
3 Stakes
800-638-0428 support@conantcollections.com
Spare Small Set Screw
Spare Medium Set Screw
Level
4 Plastic Expansion Plugs
07/2020 V.1
1