Selecting A Timer For A Heater - baraldi BEAUTY Instrucciones De Uso

INSTRUCTIONS FOR USE
• the Stop & Go LED is blinking and all the heater displays show the stop
sequence.
Stop sequence: All the heater displays show a line growing sequentially until
a round is filled, when the round is filled the round segments are switched off
sequentially. When the last segment is going to be switched off the cycle begins
again. The round segments are switched on/off anticlockwise. A new segment
is switched on/off every T_320ms.
To deactivate the stop function:
• if the [STOP_GO_KEY] is touched for more than 120 milliseconds a
beep sounds and the heaters actual power setting is reastored, or
• if the cooktop is stopped for more than 10 minutes the cooktop is
switched off automatically.
2.19 Operating the timer
It is possible for the user to set a switch off time for all heaters at any power
level. The timer value can be selected between 1 and 99 minutes. The timer last
minute will be displayed in seconds.
The [+TIMER] [-TIMER] keys will be locked:
• If the Cooktop is off, or
• if the key lock is activated (KEYLOCK LED on).
2.20 Selecting a timer for a heater
Once a heater is selected, a switch-off time can be selected by touching the
[+TIMER_KEY] or [-TIMER_KEY]. When the timer is off, it is activated by pres-
sing the timer keys [+TIMER_KEY] or [-TIMER_KEY]. A beep sounds, the timer
display shows a "00" blinking and the timed heater LED blinks.
54 / GB
Fig. 18 - Stop sequence
USE