Special Safety Instructions - Montipower BRISTLE BLASTER AXIAL Manual Del Usuario

®
BRISTLE BLASTER AXIAL
4.3

Special safety instructions

1. Before each use, check the tool for damaged and defective parts or other conditions
that may affect tool operation. Never use the tool with a defective start lever. Never
use the tool if it is damaged or set incorrectly. All damaged safety devices, start
levers or other defective parts must be repaired or replaced by an authorized service
technician.
2. When working on small or moving parts, secure them with a vise or screw clamp.
3. Only use the tool with original Bristle Blaster
system and Bristle Blaster
on Bristle Blaster
4. After replacing the Bristle Blaster
installation.
5. The Bristle Blaster
unit is equipped with a mounted air pressure regulator, which adjusts the air pressure
down to the required flow pressure.
Notice!
Please use a hose rupture protection. This protects personnel and the working environment from
damage that can occur if a compressed air system or hose bursts!
6. Check compressed air at regular intervals. To ensure that the compressed air is clean
and lubricated, integrate a maintenance unit into the compressed air line if required.
7. Ensure that the belts are not damaged when placing the tool on a work table.
8. When not in use, disconnect the tool from the compressed air supply and store it in a
suitable place to prevent accidental or unauthorized use in the absence of an
authorized operator.
9. When using the tool, always hold it by the tool body.
10. Always use Bristle Blaster
11. The Bristle Blaster
12. Never carry the tool by the compressed air hose. Protect the compressed air hose
from heat, sharp edges and being run over (use hose rupture protection).
13. If the tool suddenly feels different (vibration strength) or makes a different noise
(pitch), the tool should be switched off immediately and the accessories such as the
mounting system or Bristle Blaster
5. Compressed air supply
When using 11 mm Bristle Blaster
tool.
Correct air pressure increases the service life!
The compressed air supply must be free of water. For this reason, a water separator should
be used to prevent condensation. If the compressed air hose is too long, the tool will not be
supplied with the required air pressure. To ensure that the compressed air motor operates
properly and has a long service life, the use of a lubricator for the compressed air line is
strongly recommended.
®
Belts. Bristle Blaster
®
tools and must not be used with other accessories and other tools.
®
Belt, check the mounting system for correct
®
Axial operates optimally at a flow pressure of 75 psi (5.2 bar). The
®
Belt in it's correct working direction.
®
Belt can produce sparks when working on hard surfaces.
®
Belt should be checked for damage.
®
Belts, a flow pressure of 75 psi (5.2 bar) is required at the
Operating instructions
®
accessories such as the mounting
®
Belts are specially designed for use
EN
5